4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ASSEMBLY ADVICE

1. Assemble on a strong, level surface. Avoid assembly on a domestic carpet.

2. Use a cloth or softwood block to protect the surface finish of the product

when using a mallet. Strike the flat surface of each beam to prevent

damage to the beam.

3. Always ensure that the tabs enter fully into the slots.

4. It is recommended that the assembly should be done by two persons.

5. Always wear protective gloves when assembling the shelving unit.

6. The shelving unit is not recommended for outdoor use.

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED

•

Rubber mallet or hammer

•

Protective cloth/wood block

The tabs of the beams will often enter

the slots fully using just firm hand

pressure but if they are too tight, you

may require a rubber mallet to assist.

If so, always use a cloth to protect

the product paint finish.

Tap gently with the mallet to drive the

tabs of the beams fully into the slots in

the post. Always strike the edge close

to the post.

1. Use the short beams (D) to

connect the front and rear posts

(A) together.

NOTE: The short and long beams

should be installed with the

recessed edge uppermost to

retain the shelf.

•

Repeat this again to create the

other end assembly, making sure

that the corresponding beams

are at the same height.