4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ASSEMBLY INSTRUCTIONS

1. Assemble on a strong, level surface. Avoid assembly on a domestic carpet.

2. Use a cloth or softwood block to protect the surface finish of the product

when using a mallet. Strike the flat surface of each beam to prevent

damage to the beam.

3. Always ensure that the rivets sit at the bottom of the keyhole slots.

4. It is recommended that the assembly should be done by two persons.

5. Always wear gloves when assembling these units.

6. The shelving unit is not recommended for outdoor use.

TOOLS REQUIRED

•

Rubber mallet or hammer

•

Protective cloth/wood block

ASSEMBLY PROCEDURE

1. Assemble the supporting beams as follows.

2. The tabs of the beams will often

enter the slots fully using just firm

hand pressure but if they are too

tight, you may require a rubber

mallet to assist. If so, always use a

cloth to protect the paint finish.

3. Tap gently with the mallet to drive

the tabs of the beams fully into

the slots in the post. Always strike

the edge close to the post.

4. Use the short beams (C) to

connect the front and rear posts

together as in Fig 2.

•

The edge with the wider flange

should be installed uppermost to

support the shelf.

•

Leave a gap of 220mm below the

bottom beam and the ground.

Leave 100mm gap from the top

beam and the top of the posts.