4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

PREPARATION & USE

ADJUSTING THE HEADBAND TO FIT

The headband should be adjusted both in diameter and height to fit the

wearer’s head. To do this:

1. Press the headband adjustment knob on the back of the headband and

rotate the knob either left or right to expand or contract the headband.

2. The top headband can be adjusted by bending the strap and positioning

the peg in the appropriate hole.

ADJUSTING THE TILT ANGLE

1. Loosen the adjusting nuts slightly.

2. Move the tab onto the chosen pin

on the headband, repeat on both

sides.

NOTE: The tabs should be located on

the same pin on either side of

the headband.

3. Retighten the adjusting nuts.

4. Try the headshield on and if

necessary, readjust.

CARE & MAINTENANCE

GENERAL

Damaged components must be replaced immediately to avoid risk of eye

and face injuries. Periodically inspect the lenses. Cracked, pitted or scratched

lenses reduce vision and seriously reduce level of protection and should be

replaced with genuine, certified spare parts. The lens can be removed for

cleaning or replacement after prising out the lens retainer.

CLEANING & STORAGE

The headshield should be stored in its box or similar place.

Clean all lenses with a soft tissue and suitable lens cleaning fluid. Do not use

solvents. Never use tools or other sharp objects to remove material from the

lens or headshield. This may cause damage which may impair function and

invalidate the warranty.