14

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

PREPARATION FOR USE

FITTING THE WELDING ROD

Select the appropriate welding rod and insert it into the welding rod holder.

• It should be approximately the same thickness as the workpieces

being welded.

PREPARING THE WORKPIECE

The area being welded should be perfectly clean. Any coating, plating or

corrosion must be removed, otherwise a good weld will be impossible to

achieve.

PREPARING THE MACHINE

To prepare the machine for welding it is important that you follow the

procedure below.

1. Making sure that the ON/OFF switch, located on the rear panel is in the OFF

position, connect the welding leads as follows:

• Work clamp lead to the (-)

Negative terminal.

• Welding rod holder lead to the

(+) Positive terminal.