13

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

THE CONTROL PANEL

1. Thermal overload light. If the duty cycle is exceeded due to welding too

long with a high current, the amber overload light will illuminate and the

welder will turn off. When it has cooled down (approx. 5 to 10 minutes), the

light will go out, the power will be restored and welding can continue.

2. Power ON/OFF switch. When the power is ON the green switch will be

illuminated. When the welder is no longer required, the Power On/Off switch

should be switched to the OFF position and the plug should be disconnected

from the mains supply.

3. Current setting switches MIN-MAX & 1-2. Used together these two switches

provide 4 increasing power levels as follows:

•MIN-1

•MIN-2

•MAX-1

•MAX-2

4. Wire speed control knob. As a general rule, a higher current requires a

higher wire speed.

1. Open the cover by releasing the

locking knob on each side and

sliding the top cover back. Then

lift the cover open as shown.

2. Remove any loose items that

have been transported inside.

When closing the cover, take care to

tighten the locking knob each side of

the cover and that the cover is

secure before lifting the welder.