XRAG2 datasheet(6/33 Pages) STMICROELECTRONICS

6 / 33 page

Description

XRAG2

6/33

Description

The XRAG2 is a full-featured, low-cost integrated circuit for use in radio frequency

identification (RFID) transponders (XRAG2s) operating at UHF frequencies. It is a 432-bit

memory organized as 3 or 4 memory banks of 16-bit words as shown in Figure 4 and

Figure 5.

When connected to an antenna, the operating power is derived from the RF energy

produced by the RFID reader and incoming data are demodulated and decoded from the

received double-side band amplitude shift keying (DSB-ASK), single-side band amplitude

shift keying (SSB-ASK) or phase-reversal amplitude shift keying (PR-ASK) modulation

signal. Outgoing data are generated by antenna reflectivity variation using either FM0 or the

Miller bit coding principle (chosen by the reader).

Communications between the reader and the XRAG2 are Half-duplex, which means that the

XRAG2s does not decode reader commands while back scattering.

The data transfer rate is defined by the local UHF frequency regulation.

The XRAG2 complies with the EPC Global Class-1 Generation-2 UHF RFID specification,

revision 1.0.9, for the radio-frequency power and signal interface.

Figure 1.

Pad connections

Figure 2.

Die floor plan

AI12306

AC1

AC0

Power

Supply

Regulator

Reflecting

Modulator

ASK

Demodulator

432 bit

EEPROM

memory

(GND) AC0

ai12307

AC1

XRAG2 Datasheet(PDF) 6 Page - STMicroelectronics