M27W512 datasheet(7/22 Pages) STMICROELECTRONICS

7 / 22 page

M27W512

Device operation

7/22

Device operation

The modes of operations of the M27W512 are listed in Table 2: Operating modes. A single

power supply is required in the read mode. All inputs are TTL levels except for GVPP and

12V on A9 for Electronic Signature.

2.1

Read mode

The M27W512 has two control functions, both of which must be logically active in order to

obtain data at the outputs. Chip Enable (E) is the power control and should be used for

device selection. Output Enable (G) is the output control and should be used to gate data to

the output pins, independent of device selection. Assuming that the addresses are stable,

the address access time (tAVQV) is equal to the delay from E to output (tELQV). Data is

available at the output after a delay of tGLQV from the falling edge of G, assuming that E has

been low and the addresses have been stable for at least tAVQV-tGLQV.

2.2

Standby mode

The M27W512 has a standby mode which reduces the supply current from 15mA to 15µA

with low voltage operation VCC ≤ 3.6V, see Table 7: Read mode DC characteristics.

Characteristics table for details. The M27W512 is placed in the standby mode by applying a

CMOS high signal to the E input. When in the standby mode, the outputs are in a high

impedance state, independent of the GVPP input.

Table 2.

Operating modes(1)

X = VIH or VIL, VID = 12V ± 0.5V.

Mode

GVPP

Q7-Q0

Read

VIL

Data Out

Output Disable

VIL

VIH

Hi-Z

Program

VIL Pulse

VPP

Data In

Program Inhibit

VIH

VPP

Hi-Z

Standby

VIH

Hi-Z

Electronic Signature

VIL

VID

Codes

Table 3.

Electronic signature

Identifier

Hex data

Manufacturer code

VIL

100

000

20h

Device code

VIH

111

101

3Dh

M27W512 Datasheet(PDF) 7 Page - STMicroelectronics

M27W512 Datasheet(HTML) 7 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Datasheet Download

Link URL