| Electronic Components Datasheet Search |
|
585 Datasheet(PDF) 5 Page - Mallory performance club |
|
|
|||||||||||||||||||||||||||||
585 Datasheet(HTML) 5 Page - Mallory performance club |
|
5 / 12 page ![]() 5 MALLORY TECHNICAL SUPPORT (775) 882-6600 tech@mrgasket.com CHECKING FOR SPARK If triggering the ignition with the white wire: (See Figure 6) 1. Make sure the ignition switch is in the OFF position. 2. Remove the coil wire from the distributor cap and set the terminal approximately 1/4" from engine ground, such as the intake manifold. 3. Disconnect the HYFIRE® V Ignition Control white wire from the distributors points or ignition amplifier. 4. Turn the ignition to the ON position. Do not crank the engine. 5. Tap the white wire to ground several times. Each time you pull the wire from ground, a spark should jump from the coil wire to ground. If spark is present, the ignition is working properly. If there is no spark, skip to Step 6 below. If Triggering With the Magnetic Pickup: (See Figure 7) 1. Make sure the ignition switch is in the OFF position. 2. Remove the coil wire from the distributor cap and set the terminal approximately 1/4" from engine ground, such as the intake manifold. The illustrations on the following pages show the best way to install the HYFIRE® V Ignition Control on various applications. If you have any problems or questions while installing this device on your vehicle, contact the Mallory Technical Service Department at (775) 882-6600, 8:00 AM to 5:00 PM Pacific time, or email tech@mrgasket.com. 3. Disconnect the HYFIRE® V Ignition Control magnetic pickup wires from the distributor. 4. Turn the ignition to the ON position. Do not crank the engine. 5. With a small jumper wire, short the HYFIRE® V Ignition Control green and violet magnetic pickup wires together. Each time you break this short, a spark should jump from the coil wire to ground. If spark is present, the ignition is working properly. If there is no spark skip to Step 6 below. 6. If there is no spark. A. Inspect all of the wiring. B. Substitute another coil and repeat the test. If there is now spark, the coil is at fault. C. If there is still no spark, check to make sure there is 12 volts on the small red wire from the HYFIRE® V Ignition Control when the key is in the ON position. If 12 volts is not present, find another switched 12 volts source and repeat the test. D. If, after following the test procedures and inspecting all of the wiring, there is still no spark, the HYFIRE® V Ignition Control is probably in need of repair. See the Warranty and Service sec- tion for information. TO GROUND WHITE WIRE FIGURE 6 JUMPER WIRE GREEN VIOLET FIGURE 7 |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |