MAXQ3181-RAN+ datasheet(21/84 Pages) MAXIM

21 / 84 page

Low-Power, Active Energy, Polyphase AFE

______________________________________________________________________________________

Table 2. Command Format for SPI Register Write

BYTE

TRANSFERS

BIT

DESCRIPTION

7:6

Command code:

00 Read

01 Reserved

10 Write

11 Reserved

5:4

Data Length:

00 1 Byte

01 2 Bytes

10 4 Bytes

11 8 Bytes

1st byte

Master sends command;

Slave sends 0xC1 byte

3:0

MSB portion of data address.

2nd byte

Master sends address;

Slave sends 0xC2 byte

7:0

LSB portion of data address.

3rd byte

(1st data byte)

Master sends data;

Slave sends ACK (0x41)

7:0

Data, LSB

...

Nth byte

(Last data byte)

Master sends data;

Slave sends ACK (0x41)

7:0

Data, MSB

(N + 1) byte

Master sends CRC;

Slave sends ACK (0x41)

7:0

Optional CRC

Sync bytes

Master sends dummy;

Slave sends ACK (0x41) or

NACK (0x4E) byte

7:0

Master sends dummy byte; Slave responds with NACK if busy,

or with ACK when processing complete.

Master must receive ACK before starting the next transaction.

example, if synchronization is lost), the host only needs

to wait for the SPI to time out before restarting commu-

nication from the first command byte. SPI timeout count

starts after receiving the first command byte from the

master (after the 8th SPI clock of the first byte). The

count stops and clears after receiving the last byte of a

transaction (after the 8th SPI clock of the last byte).

If the timeout count expires (exceeds COM_TIMO)

before the transaction completes, the MAXQ3181 aban-

dons the unfinished transaction and resets the SPI logic

to be ready for the next transaction. The default SPI

timeout is 320ms.

Optionally, a CRC byte can be appended to each

transaction. For write commands, the CRC byte is sent

by the master, and for read commands the CRC byte is

sent by the MAXQ3181. The CRC mode is enabled

when the CRCEN bit is set to 1 in OPMODE1 register.

Otherwise, the MAXQ3181 assumes no CRC byte is

used. The 8-bit CRC is calculated for all bytes in a

transaction, from the first command byte sent by the

master through the last data byte excluding sync bytes,

using the polynomial P = x8 + x5 + x4 + 1. If the trans-

mitted CRC byte does not match the calculated CRC

byte (for a write command), the MAXQ3181 ignores the

command.

MAXQ3181-RAN+ Datasheet(PDF) 21 Page - Maxim Integrated Products

MAXQ3181-RAN+ Datasheet(HTML) 21 Page - Maxim Integrated Products

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

Datasheet Download

Link URL