US1010

2-4

Rev. 1.3

10/30/00

Output Voltage Setting

The US1010 can be programmed to any voltages in the

range of 1.25V to 5.5V with the addition of R1 and R2

external resistors according to the following formula:

Figure 2 - Typical application of the US1010

for programming the output voltage.

The US1010 keeps a constant 1.25V between the out-

put pin and the adjust pin. By placing a resistor R1 across

these two pins a constant current flows through R1, add-

ing to the Iadj current and into the R2 resistor producing

a voltage equal to the (1.25/R1)*R2 +

be added to the 1.25V to set the output voltage. This is

summarized in the above equation. Since the minimum

load current requirement of the US1010 is 10 mA , R1 is

typically selected to be 121

matically satisfies the minimum current requirement.

Notice that since Iadj is typically in the range of 50uA it

only adds a small error to the output voltage and should

only be considered when a very precise output voltage

setting is required. For example, in a typical 3.3V appli-

cation where R1=121

Iadj is only 0.3% of the nominal set point.

Load Regulation

Since the US1010 is only a 3 terminal device , it is not

possible to provide true remote sensing of the output

voltage at the load.Figure 3 shows that the best load

Figure 3 - Schematic showing connection for best load

regulation

Stability

The US1010 requires the use of an output capacitor as

part of the frequency compensation in order to make the

regulator stable. Typical designs for microprocessor ap-

plications use standard electrolytic capacitors with a

typical ESR in the range of 50 to 100 m

capacitance of 500 to 1000uF. Fortunately as the ca-

pacitance increases, the ESR decreases resulting in a

fixed RC time constant. The US1010 takes advantage of

this phenomena in making the overall regulator loop

stable.For most applications a minimum of 100uF alu-

minum electrolytic capacitor such as Sanyo MVGX se-

ries ,Panasonic FA series as well as the Nichicon PL

series insures both stability and good transient response.

regulation is achieved when the bottom side of R2 is

connected to the load and the top side of R1 resistor is

connected directly to the case or the Vout pin of the

regulator and not to the load. In fact , if R1 is connected

to the load side, the effective resistance between the

regulator and the load is gained up by the factor of (1+R2/

R1) ,or the effective resistance will be ,Rp(eff)=Rp*(1+R2/

R1).It is important to note that for high current applica-

tions, this can represent a significant percentage of the

overall load regulation and one must keep the path from

the regulator to the load as short as possible to mini-

mize this effect.

V

V

R

R

I

R

Where :

V Typically

I

lly

R

in figure

OUT

REF

ADJ

REF

ADJ

=

+









+

×

1

125

50

2

2

1

2

1

2

V

= .

=

uA Typica

& R as shown

Vout

1010app2-1.0

R1

R2

Vin

Vref

IAdj = 50uA

US1010

Adj

Vout

Vin

1010app3-1.0

R1

R2

Vin

RL

Rp

PARASITIC LINE

RESISTANCE

US1010

Adj

Vout

Vin