UM/MC3

4

Installation

Using Trim Pieces

Ramp Trim with Yellow PVC Cover: UMRT4/UMRT8

Secures the edges of the Safety Mats to the floor.

It is composed of two parts with an aluminum base and a PVC Cover.

Joining Trim: UMJS4/UMJS8

The Joining Trims join the Safety Mats when two or more Safety Mats

are being combined.

In addition to joining the Safety Mats, the Joining Trims preserve the

Safety Mat's sensitivity at the joints.

Aluminum Ramp Trim: UMAL

Secures the edges of the Safety Mat to the floor.

The Aluminum Ramp Trim is hollow, so cable can be routed through

it.

Molded Outside Corner: UMOC

Used together with the Ramp Trim with Yellow PVC Cover (UMRT4/

UMRT8) to secure the external corners of the Safety Mats to the floor.

Molded Inside Corner: UMIC

Used together with the Ramp Trim with Yellow PVC Cover (UMRT4/

UMRT8) to secure the internal corners of the Safety Mats to the floor.

Note: 1. The Aluminum Ramp Trim or Ramp Trim with Yellow PVC

Cover must be cut to fit the size of the Safety Mats being

used.

Furthermore, when the Safety Mat's wiring is being routed

through the Aluminum Ramp Trim or Ramp Trim with Yellow

PVC Cover, it will be necessary to cut or notch the

Aluminum Ramp Trim or Ramp Trim with Yellow PVC Cover

for cable access.

Refer to the Safety Mat Instruction Sheet for details on

cutting or notching the Aluminum Ramp Trim or Ramp Trim

with Yellow PVC Cover.

2. The Joining Trim must be cut to fit the size of the Safety

Mats being used.

3. The Ramp Trim with Yellow PVC Cover and Molded Corner

must be anchored to the floor to secure the Safety Mats. It

is also necessary to drill holes in the Trim to anchor it.

Refer to the Safety Mat Instruction Sheet for details on

drilling holes in the Trim and Molded Corner and anchoring

it to the floor.

Safety Mat Configuration

The Safety Mats are secured by anchoring the Ramp Trim with Yellow

PVC Cover and Molded Corner to the floor.

Before ordering, confirm the number of Ramp Trim with Yellow PVC

Cover and Molded Corner pieces that will be needed.

Example 1: Using a Single Safety Mat

In this case, the perimeter of the Safety Mat is about 4 m and the

following pieces are required:

The example above consists of the following components:

UMYM5-1000-1000 Safety Mat

: 1 piece

UMRT4 Ramp Trim with Yellow PVC Cover (1.22 m) : 4 pieces

UMOC Molded Outside Corner

: 4 pieces

Example 2: Using three Safety Mats

In this case, the perimeter of the Safety Mat is about 8 m, the joint

between the Safety Mats is 2-m long, and the following pieces are

required:

The example above consists of the following components:

UMYM5-1000-1000 Safety Mat

: 3 pieces

UMRT4 Ramp Trim with Yellow PVC Cover (1.22 m) : 8 pieces

UMJS4 Joining Trim (1.22 m)

: 2 pieces

UMOC Molded Outside Corner

: 5 pieces

UMIC Molded Inside Corner

: 1 piece

UMYM5-1000-1000

UMOC

UMRT4

UMOC

UMRT4

UMOC

UMOC

UMIC

UMJS4

UMYM5-1000-1000

UMYM5-1000-1000

UMYM5-1000-1000