CDCE706 datasheet(31/40 Pages) TI

31 / 40 page

Performance Data: Output Skew, Jitter, Cross-Coupling, Noise Rejection (Spur Suppression),

Output Skew

Jitter Performance

CDCE706

www.ti.com ........................................................................................................................................... SCAS815I – OCTOBER 2005 – REVISED NOVEMBER 2008

and Phase Noise

Skew is an important parameter for clock distribution circuits. It is defined as the time difference between outputs

that are driven by the same input clock. Table 5 shows the output skew (tsk(o)) of the CDCE706 for high-to-low

and low-to-high transitions over the entire range of supply voltages, operating temperature and output voltage

swing.

Table 5. Output Skew

PARAMETER

CONDITION

TYP

MAX

UNIT

VCCOUT = 2.5 V

130

250

tsk(o)

Output skew

VCCOUT = 3.3 V

130

200

Jitter is a major parameter for PLL-based clock driver circuits. This becomes important as speed increases and

timing budget decreases. The PLL and internal circuits of CDCE706 are designed for lowest jitter. The

peak-to-peak period jitter is only 60 ps (typical). Table 6 gives the peak-to-peak and rms deviation of

cycle-to-cycle jitter, period jitter and phase jitter as taken during characterization.

Table 6. Jitter Performance of CDCE706

TYP(1)

MAX(1)

PARAMETER

CONDITION

UNIT

rms

Peak-Peak

(One Sigma)

fout = 50 MHz

–

tjit(cc)

Cycle-to-cycle jitter

fout = 133 MHz

–

fout = 245.76 MHz

–

fout = 50 MHz

tjit(per)

Period jitter

fout = 133 MHz

fout = 245.76 MHz

fout = 50 MHz

730

840

115

tjit(phase)

Phase jitter

fout = 133 MHz

930

130

1310

175

fout = 245.76 MHz

720

930

125

(1)

All typical and maximum values are at VCC = 3.3 V, temperature = 25°C, VCCOUT = 3.3 V; one output is switching, data taken over

several 10,000 cycles.

Figure 26, Figure 27, and Figure 28 show the relationship between cycle-to-cycle jitter, period jitter, and phase

jitter over 10,000 samples. The jitter varies with a smaller or wider sample window. The cycle-to-cycle jitter and

period jitter show the measured value, whereas the phase jitter is the accumulated period jitter.

Cycle-to-Cycle jitter (tjit(cc)) is the variation in cycle time of a clock signal between adjacent cycles, over a random

sample of adjacent cycle pairs. Cycle-to-cycle jitter is never greater than the period jitter. It is also known as

adjacent-cycle jitter.

Submit Documentation Feedback

Product Folder Link(s): CDCE706

CDCE706 Datasheet(PDF) 31 Page - Texas Instruments

CDCE706 Datasheet(HTML) 31 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Datasheet Download

Link URL