Continued from preceding page.

Usage Notes

1. Option specification

When using a Sanyo cross assembler with the LC66E5316, use the version called “LC66S.EXE” and specify the

actual microcontroller to be evaluated with the CPU pseudo instruction in the source file. The port options must be

specified in the source file. The cross assembler will create an option code list in the option specification area

(locations 3FF0H to 3FFFH). It is also possible to directly set up data in the option specification area. If this is done,

the options must be specified according to the option code creation table shown on the following page.

2. Writing the EPROM

Use a special-purpose writing conversion board (the W66EP5316D for the DIP package, and the W66EP5316Q for

the QFP package) to allow the EPROM programmers listed below to be used when writing the data created by the

cross assembler to the LC66E5316.

• The EPROM programmers listed below can be used.

range to location 0 to 3FFFH. The DASEC jumper must be off.

3. Using the data security function

The data security function sets up the microcontroller in advance so that data that was written to the microcontroller

EPROM cannot be read out.

Use the following procedure to enable the LC66E5316 data security function.

• Set the write conversion board DASEC jumper to the on position.

• Write the data to the EPROM once again.

At this time, since this function will operate, the EPROM programmer will issue an error. However, this error does

not indicate that there was a problem in either the programmer or the LSI.

Notes: 1. If the data at all addresses was “FF” at step 2, the data security function will not be activated.

→ program → verify” operation

sequence is used.

No. 5488-13/27

LC66E5316

ROM area

Bit

Option specified

Option/data relationship

7

6

5

3FFEH

4

Reserved. Must be set to predefined data values.

This data is generated by the assembler.

3

If the assembler is not used, set this data to ‘00’.

2

1

0

7

6

5

3FFFH

4

Reserved. Must be set to predefined data values.

This data is generated by the assembler.

3

If the assembler is not used, set this data to ‘00’.

2

1

0

Manufacturer

Models that can be used

Advantest

R4945, R4944A, R4943, or equivalent products

Ando

AF9704

AVAL

—

Minato Electronics

MODEL1890A