AFE8220TPZPQ1 datasheet(29/49 Pages) TI1

29 / 49 page

Real-Time Clock Alarm

GPIO

AFE8220-Q1

www.ti.com....................................................................................................................................................... SBAS455A – JANUARY 2009 – REVISED JULY 2009

Invalid combinations of rtc_day and rtc_month (trying to set February 30, for example) cause unpredictable

behavior and should be avoided. The February 28/29 rollover variation based on leap year is automatically

corrected for.

The RTC defaults to operate in 12-hour plus AM/PM mode. To operate in 24-hour mode (where the AM/PM bits

are disabled) set rtc_mode to 1. Care must be taken when switching between AM/PM mode and 24-hour mode

to avoid setting the time to a invalid value. See Figure 18 and Figure 19 for the proper procedures.

The real-time clock alarm function can be used to generate an interrupt (or a wakeup interrupt) at a

pre-programmed time. If the appropriate bit in an interrupt enable register is set, an interrupt will be generated

when the values in the RTC time registers become equal to the values in the RTC alarm registers. The register

settings are shown in Table 15.

Table 15. RTC Alarm Control Register Settings

PARAMETER

ADDRESS

BITS

rtc_seconds_alarm[6:0]

6:0

rtc_minutes_alarm[6:0]

6:0

rtc_hours_alarm[5:0]

5:0

rtc_ampm_alarm

rtc_day_alarm[5:0]

5:0

rtc_month_arlarm[4:0]

4:0

rtc_year_alarm[7:0]

7:0

Eight general-purpose I/O pins are provided, labeled GPIO0 through GPIO7. The direction of the eight GPIO pins

can be independently set through control variable gpio_oe(7:0). A pin is an input if the corresponding bit of

gpio_oe is 0; a pin is an output if the corresponding bit of gpio_oe is 1.

The control variable gpio(7:0) serves different functions, depending on whether it is read from or written to. A

read operation from gpio returns the logic state of the eight GPIO pins regardless of their direction. A write to

gpio sets the output state of the GPIO pins if they are configured as outputs; there is no effect if the pin is

configured as an input. Note that the write value of gpio is stored in a register, so that if a GPIO pin is changed

from an input to an output its logic state is set by the stored value of gpio. Table 18 shows the gpio control

variable settings.

The GPIO inputs can be optionally debounced if an RTC oscillator is running. Debouncing is controlled by

gpio_delay, which is divided into eight 2-bit fields, each controlling a particular GPIO input according to Table 16.

Table 16. gpio_delay

[15:14]

[13:12]

[11:10]

[9:8]

[7:6]

[5:4]

[3:2]

[1:0]

GPIO7

GPIO6

GPIO5

GPIO4

GPIO3

GPIO2

GPIO1

GPIO0

Submit Documentation Feedback

Product Folder Link(s): AFE8220-Q1

AFE8220TPZPQ1 Datasheet(PDF) 29 Page - Texas Instruments

AFE8220TPZPQ1 Datasheet(HTML) 29 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

Datasheet Download

Link URL