www.ti.com

1

FEATURES

DESCRIPTION

TUSB6010BZQE, TUSB6010BIZQE

SLLA269 – OCTOBER 2007

www.ti.com

USB2.0 High Speed (HS) On-the-Go (OTG) Dual Role Controller

• Configurable for up to 15 transmit endpoints

and up to 15 receive endpoints

• USB 2.0 HS OTG Dual Role Controller Core

–

16 kilobyte RAM for USB endpoint FIFO

–

Act as a USB 2.0 HS Peripheral

shared by USB IN/OUT endpoints

–

Act as a USB 2.0 HS Embedded Host

–

Configurable FIFOs, including the option of

Controller

dynamic FIFO sizing

–

Act as a USB 2.0 HS OTG Device

–

Support for external DMA access to FIFOs

–

Supports Session Request Protocol

• Power Management Module

(SRP)

–

Ultra low power Idle mode for battery

–

Supports Host Negotiation Protocol

conscious applications

(HNP)

–

Support for External Charge Pump

• Integrated USB 2.0 OTG PHY

• TUSB6010BZQE/TUSB6010BIZQE are RoHS

• NOR FLASH - Like External Host Interface

compliant.

• 80 Terminal BGA Microstar Junior Package

The TUSB6010B is a USB 2.0 HS Dual Role USB Controller designed for seamless interface to an external Host

processor through the NOR FLASH-like interface. The TUSB6010B can be used to enable the processor to

implement any one of three genral types of USB devices. It can be implemented as a USB high-speed peripheral

(or target), as a USB high-speed, single-port, embedded host controller, or as a USB high-speed OTG device.

Software on the application processor will be required to implement the chosen type of USB device.

The NOR FLASH-like interface is a multiplexed, 16-bit interface with support for burst and single read/write

access. It can operate in both synchronous and asynchronous modes.

The Power Management Module provides external USB OTG Charge Pump control through the power

control/status interface. The Power Management Module provides a seamless interface to the TPS65030 Power

Management IC for USB-OTG.

The device also has eight user configurable general purpose I/0 interface pins. The GPIO can be configured as

an interrupt or wakeup source. Some GPIO have secondary NOR-flash DMA Request functionality.

The device is fully compliant with the Universal Serial Bus Specification Rev. 2.0 and On-The-Go Supplement to

the USB Specification Rev. 1.3.

The ESD protection level is 2KV HBM (JESD22-A114D), 500V CDM (JESD22-C101C).

NOTE:

This product is intended for high-volume handset applications only. Contact

support@ti.com for more information.

1

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of

Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

Submit Documentation Feedback

Copyright © 2007, Texas Instruments Incorporated