| Electronic Components Datasheet Search |
|
8009B Datasheet(PDF) 2 Page - Emcore Corporation |
|
|
|||||||||||||||||||||||||||||
8009B Datasheet(HTML) 2 Page - Emcore Corporation |
|
2 / 19 page ![]() 2 2 Data Sheet, Rev. 0 System 8000 Fiber-Optic Interfacility Links March 6, 2003 ORTEL a Division of EMCORE Description (continued) n Remote RF monitor links measure the composite uplink signal at the uplink EIRP monitor coupler located at the antenna’s input feed flange. n Monitor and control data link provides a full-duplex, fiber-optic path for either RS-232C or RS-422 data for the earth station’s monitor and control system. Status information, including alarms and warnings, is indicated by front panel LEDs and through standard system monitor and control serial data ports on the chassis rear panel. Absolute Maximum Ratings Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are abso- lute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess of those given in the operational sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect device reliability. *A 500 V transient developed across 100 pF is discharged through 1500 Ω to each connector pin without damaging the system. Typical Block Diagram As indicated in the block diagram below, the input and output amplifiers are integral to the system 8000. The tables presented throughout the following sections, however, give the expected performance of each functional block in the link with respect to their corresponding performance bands, including 70 MHz—140 MHz, L-band, and C-, X-, and Ku-band interfacility links. These specifications, along with those for remote RF signal monitor interfacility links and fiber-optic data links, are presented to aid in generating level diagrams for overall system analysis. Parameter Symbol Min Max Unit Operating Temperature Range TC 050 °C Storage Temperature Range Tstg –20 +60 °C Power Requirements: 8001A Chassis With 8010A (Factory Set) Status and Control Plug Transmitter Plug-in Receiver Plug-in — 115/60 — — — 230/50 5 18 5.2 Vac/Hz W W W RF Input RFIN —2 V Surge Protection* — — — — Humidity, Noncondensing RH 5 95 % RF IN RF OUT LOSS = 4 dB NF = 4 dB FIBEROPTIC LINK OUTPUT AMP REDUNDANCY SWITCHING UNIT (RSU) REDUNDANCY SWITCHING UNIT (RSU) INPUT AMP LOSS = 2 dB NF = 2 dB |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |