- AD VA NCE D IN F O RMA T IO N -

LTP5903-WHR Datasheet

Dust Networks

11

7.2

Software Interfaces

The LTP5903-WHR provides well-defined software interfaces for easy integration. Table 20 describes which interfaces are

available via the various hardware ports. This section describes the software interfaces available via the hardware ports

described in section 7.2.1.

Table 20 LTP5903-WHR Software Interfaces

Hardware Port

Software Interface

Comments

Ethernet

XML API, Admin Toolset

Serial 1

<reserved>

Serial 2

Command line interface

7.2.1

XML API

The XML API is an open Extensible Markup Language (XML) interface that lets a client application send Remote Procedure

Call (RPC) requests to the LTP5903-WHR and receive responses and other data from the LTP5903-WHR via XML-RPC.

The API consists of a Control Channel and a Notification Channel. The Control Channel is used to establish connection and

exchange commands and information about the SmartMesh Network. The Notification Channel is used to stream data and

network events to the client program

7.2.2

Admin Toolset

The LTP5903-WHR provides a Web-based administrative tool called Admin Toolset. Through this interface, users may

configure IP settings, view logs, manually configure the system time, or enable the Network Time Protocol (NTP) client.

Users may also update LTP5903-WHR software as well as perform remote software updates on motes in the wireless

network.

7.2.3

Command Line Interface

The command line interface is for troubleshooting with the assistance of Dust Networks support.

8.0

Board-to-board Connectors

The LTP5903-WHR has two 40-pin FCI/Berg 61083-042400LF board-to-board connectors. For connector and pin locations,

see Figure 3 and Figure 4.

8.1

Connector Pin Numbering

Figure 3

Connector Pin Numbering (Bottom View)