MPC8315CVRADDA datasheet(7/106 Pages) FREESCALE

7 / 106 page

MPC8315E PowerQUICC II Pro Processor Hardware Specifications, Rev. 2

Freescale Semiconductor

MPC8315E Features

2.12

Power Management Controller (PMC)

The MPC8315E supports a range of power management states that significantly lower power consumption

under the control of the power management controller. The PMC includes the following features:

•

Provides power management when the device is used in both PCI host and agent modes

•

PCI Power Management 1.2 D0, D1, D2, D3hot, and D3cold states

•

PME generation in PCI agent mode, PME detection in PCI host mode

•

Wake-up from Ethernet (magic packet), USB, GPIO, and PCI (PME input as host) while in the D1,

D2 and D3hot states

•

A new low-power standby power management state called D3warm

— The PMC, one Ethernet port, and the GTM block remain powered via a split power supply

controlled through an external power switch

— Wake-up events include Ethernet (magic packet), GTM, GPIO, or IRQ inputs and cause the

device to transition back to normal operation

— PCI agent mode is not be supported in D3warm state

•

PCI Express-based PME events are not supported

2.13

Serial Peripheral Interface (SPI)

The serial peripheral interface (SPI) allows the MPC8315E to exchange data between other PowerQUICC

family chips, Ethernet PHYs for configuration, and peripheral devices such as EEPROMs, real-time

clocks, A/D converters, and ISDN devices.

The SPI is a full-duplex, synchronous, character-oriented channel that supports a four-wire interface

(receive, transmit, clock, and slave select). The SPI block consists of transmitter and receiver sections, an

independent baud-rate generator, and a control unit.

2.14

DMA Controller, I2C, DUART, Enhanced Local Bus Controller

(eLBC), and Timers

The integrated four-channel DMA controller includes the following features:

•

Allows chaining (both extended and direct) through local memory-mapped chain descriptors

(accessible by local masters)

•

Misaligned transfer capability for source/destination address

•

Supports external DREQ, DACK and DONE signals

There is one I2C controller. This synchronous, multi-master buses can be connected to additional devices

for expansion and system development.

The DUART supports full-duplex operation and is compatible with the PC16450 and PC16550

programming models. 16-byte FIFOs are supported for both the transmitter and the receiver.

The eLBC port allows connections with a wide variety of external DSPs and ASICs. Three separate state

machines share the same external pins and can be programmed separately to access different types of

devices. The general-purpose chip select machine (GPCM) controls accesses to asynchronous devices

MPC8315CVRADDA Datasheet(PDF) 7 Page - Freescale Semiconductor, Inc

MPC8315CVRADDA Datasheet(HTML) 7 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL