Rev. 1.1 / Apr. 2013

3

Description

chronous DRAM, ideally suited for the main memory applications which requires large memory density,

high bandwidth and low power operation at 1.35V. DDR3L SDRAM provides backward compatibility with

the 1.5V DDR3 based environment without any changes. (Please refer to the SPD information for details.)

SK hynix 2Gb DDR3L SDRAMs offer fully synchronous operations referenced to both rising and falling

edges of the clock. While all addresses and control inputs are latched on the rising edges of the CK (falling

edges of the CK), Data, Data strobes and Write data masks inputs are sampled on both rising and falling

edges of it. The data paths are internally pipelined and 8-bit prefetched to achieve very high bandwidth.

Device Features and Ordering Information

FEATURES

• VDD=VDDQ=1.35V + 0.100 / - 0.067V

• Fully differential clock inputs (CK, CK) operation

• Differential Data Strobe (DQS, DQS)

• On chip DLL align DQ, DQS and DQS transition with CK



transition

• DM masks write data-in at the both rising and falling



edges of the data strobe

• All addresses and control inputs except data, data

strobes and data masks latched on the rising edges of

the clock

• Programmable CAS latency 5, 6, 7, 8, 9, 10, 11, 13

supported

• Programmable additive latency 0, CL-1, and CL-2



supported

• Programmable CAS Write latency (CWL) = 5, 6, 7, 8, 9

• Programmable burst length 4/8 with both nibble



sequential and interleave mode

• BL switch on the fly

• 8banks

• JEDEC standard 78ball FBGA(x4/x8)

• Driver strength selected by EMRS

• Dynamic On Die Termination supported

• Asynchronous RESET pin supported

• ZQ calibration supported

• TDQS (Termination Data Strobe) supported (x8 only)

• Write Levelization supported

• 8 bit pre-fetch

• This product in compliance with the RoHS directive.