PCA8536 datasheet(21/74 Pages) NXP

21 / 74 page

PCA8536

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 2 — 21 February 2012

21 of 74

NXP Semiconductors

PCA8536

Automotive LCD low multiplex driver with 6 channel PWM generator

8.1.15 Command: write-PWM-data

This command will initiate the transfer of data to the PWM registers. Data will be written

into the address defined by the load-data-pointer-PWM command. PWM register filling is

described in Section 8.10

[1]

For this command to be effective bit RS[1:0] of the control byte has to be set logic 10, see Table 36 on

page 46.

[2]

Default value. After Power-On Reset (POR) the PWM content is set to 0.

8.2 Start-up and shut-down

8.2.1 Reset and Power-On Reset (POR)

After a reset and at power-on the PCA8536 resets to starting conditions as follows:

1. The display is disabled.

2. All backplane outputs are set to VSS.

3. All segment outputs are set to VSS.

4. All GPO outputs are disabled.

5. Selected drive mode is: 1:8 with 1⁄4 bias.

6. The data pointers are cleared (set logic 0).

7. PWM values are all reset to zero.

8. RAM data is not initialized. Its content can be considered to be random.

9. The internal oscillator is running; no clock signal is available on pin OSCCLK; pin

OSCCLK is in 3-state.

The reset state is as shown in Table 29.

Table 28.

Write-PWM-data - write PWM data command bit description[1]

Bit

Symbol

Value

Description

fixed value

6 to 0

P[6:0]

0000000[2] to

1111111

writing data byte-wise to PWM registers

PCA8536 Datasheet(PDF) 21 Page - NXP Semiconductors

PCA8536 Datasheet(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74

Datasheet Download

Link URL