CAT24C021J-30TE13 datasheet(10/12 Pages) CATALYST

10 / 12 page

CAT24CXX1/XX2

Advanced

Doc. No. 25079-00 1/98 M-1

SLAVE

ADDRESS

BUS ACTIVITY:

MASTER

SDA LINE

BYTE

ADDRESS (n)

DATA n

SLAVE

ADDRESS

BUS ACTIVITY:

MASTER

SDA LINE

DATA n+x

DATA n

DATA n+1

DATA n+2

SLAVE

ADDRESS

Figure 10. Selective Read Timing

Figure 11. Sequential Read Timing

24C1601Fig.9

24C1601Fig.10

Immediate/Current Address Read

The CAT24CXXX’s address counter contains the ad-

dress of the last byte accessed, incremented by one. In

other words, if the last READ or WRITE access was to

address N, the READ immediately following would ac-

cess data from address N+1. If N=E (where E= 255 for

24C021/022, E=511 for 24C041/042, E=1023 for

24C081/082 and E=2047 for 24C161/162) then the

counter will ‘wrap around’ to address 0 and continue to

clock out data. After the CAT24CXXX receives its slave

address information (with the R/

W bit set to one), it

issues an acknowledge, then transmits the 8-bit byte

requested. The master device does not send an ac-

knowledge, but will generate a STOP condition.

Selective/Random Read

Selective/Random READ operations allow the Master

device to select at random any memory location for a

READ operation. The Master device first performs a

‘dummy’ write operation by sending the START condi-

tion, slave address and byte addresses of the location it

wishes to read. After CAT24CXXX acknowledges, the

Master device sends the START condition and the slave

address again, this time with the R/

W bit set to one.

The CAT24CXXX then responds with its acknowledge

and sends the 8-bit byte requested. The master device

Sequential Read

The Sequential READ operation can be initiated by

either the Immediate Address READ or Selective READ

operations. After the CAT24CXXX sends the initial 8-bit

byte requested, the Master will respond with an

acknowledge which tells the device it requires more

data. The CAT24CXXX will continue to output an 8-bit

byte for each acknowledge sent by the Master. The

operation will terminate when the Master fails to respond

with an acknowledge, thus sending the STOP condition.

The data being transmitted from CAT24CXXX is output-

ted sequentially with data from address N followed by

data from address N+1. The READ operation address

counter increments all of the CAT24CXXX address bits

so that the entire memory array can be read during one

operation. If more than E (where E= 255 for 24C021/

022, E=511 for 24C041/042, E=1023 for 24C081/082

and E=2047 for 24C161/162) bytes are read out, the

counter will ‘wrap around’ and continue to clock out data

bytes.

does not send an acknowledge but will generate a STOP

condition.

CAT24C021J-30TE13 Datasheet(PDF) 10 Page - Catalyst Semiconductor

CAT24C021J-30TE13 Datasheet(HTML) 10 Page - Catalyst Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Datasheet Download

Link URL