AT90PWM2 datasheet(284/365 Pages) ATMEL

284 / 365 page

284

4317K–AVR–03/2013

AT90PWM2/3/2B/3B

25.4

Signature Bytes

All Atmel microcontrollers have a three-byte signature code which identifies the device. This

code can be read in both serial and parallel mode, also when the device is locked. The three

bytes reside in a separate address space.

25.4.1

Signature Bytes

For the AT90PWM2/3 the signature bytes are:

0x000: 0x1E (indicates manufactured by Atmel).

0x001: 0x93 (indicates 8KB Flash memory).

0x002: 0x81 (indicates AT90PWM2/3 device when 0x001 is 0x93).

For the AT90PWM2B/3B the signature bytes are:

0x000: 0x1E (indicates manufactured by Atmel).

0x001: 0x93 (indicates 8KB Flash memory).

0x002: 0x83 (indicates AT90PWM2B/3B device when 0x001 is 0x93).

25.5

Calibration Byte

The AT90PWM2/2B/3/3B has a byte calibration value for the internal RC Oscillator. This byte

resides in the high byte of address 0x000 in the signature address space. During reset, this byte

is automatically written into the OSCCAL Register to ensure correct frequency of the calibrated

RC Oscillator.

25.6

Parallel Programming Parameters, Pin Mapping, and Commands

This section describes how to parallel program and verify Flash Program memory, EEPROM

Data memory, Memory Lock bits, and Fuse bits in the AT90PWM2/2B/3/3B. Pulses are

assumed to be at least 250 ns unless otherwise noted.

25.6.1

Signal Names

In this section, some pins of the AT90PWM2/2B/3/3B are referenced by signal names describing

their functionality during parallel programming, see Figure 25-1 and Table 25-7. Pins not

described in the following table are referenced by pin names.

The XA1/XA0 pins determine the action executed when the XTAL1 pin is given a positive pulse.

The bit coding is shown in Table 25-9.

When pulsing WR or OE, the command loaded determines the action executed. The different

Commands are shown in Table 25-10.

AT90PWM2 Datasheet(PDF) 284 Page - ATMEL Corporation