AN3311 datasheet(32/58 Pages) STMICROELECTRONICS

32 / 58 page

Getting started with the system

AN3311

32/58

Doc ID 18209 Rev 1

Figure 11.

IAR embedded workbench main window

On the main node, where the program name located in the files window is shown, right click

the mouse button and select options. In the window which appears, select the debugger

item in the category list box, and select the proper debugging tool in the driver list box, then

press the Ok button. In the proposed example the J-Link dongle is used (Figure 12).

Press the Make icon or click on Project\Rebuild All. No error or warning should appear once

compiling has completed. Connect the J-Link tool to the USB port of the PC, and connect

the flat cable with the programming adapter. Plug the adapter into the dongle connector.

Press the debug icon, CTRL+D or click project\debug. The debugger starts to download the

firmware to the dongle through the J-Link debugger\programmer. Press the Go button, F5 or

click debug\go in order to execute the firmware in debug mode. To run the dongle in

standalone mode, press the stop debugging icon, CTRL+SHIFT+D or click debug\stop

debugging. Then remove the J-link adapter from the dongle and reset the board by

unplugging and plugging the power cable back in.

Figure 12.

IAR embedded workbench debugger options

AN3311 Datasheet(PDF) 32 Page - STMicroelectronics