UM1653 datasheet(36/45 Pages) STMICROELECTRONICS

Part #	UM1653

Description	STM32 Advanced NAND Flash Driver for SLC NAND

PDF	45 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

36 / 45 page

NAND evaluation board

UM1653

36/45

DocID025024 Rev 1

Figure 11. Evaluation board: bottom side

Note:

The USB High Speed section is only present in STEVAL-CCM007V1, STEVAL-CCM007V2,

STEVAL-CCM008V1 and STEVAL-CCM008V2.

3.1.1

Running in USB Mass Storage mode (STEVAL-CCM006/7/8V1)

The STEVAL-CCM006V1, STEVAL-CCM007V1, STEVAL-CCM008V1 boards are

programmed for USB Full Speed by default. To run USB High Speed, you must program the

board using proper firmware using available tool chain.

Connect the mini-USB cable between a jumper on the PCB and the Host (PC)

–

J4 for USB FS Demo.

–

J7 for USB HS Demo.

The device is detected as a USB mass storage device in Device Manager of Host (PC).

The device appears as a Removable Drive on the Host (PC).

MS33245V1

RESET switch

Mini USB Port (Full Speed)

Voltage Regulator

NAND Flash

Micro USB Port (High Speed)

USB High Speed PHY*

NAND Flash socket footprint

STM32

UM1653 Datasheet(PDF) 36 Page - STMicroelectronics