Electronic Components Datasheet Search
  English  ▼

X  

MAX9360ESA Datasheet(PDF) 7 Page - Maxim Integrated Products

Part # MAX9360ESA
Description  LVTTL/TTL/CMOS-to-Differential LVECL/ ECL Translators
PDF  9 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Manufacturer  MAXIM [Maxim Integrated Products]
Direct Link  https://www.maximintegrated.com/en.html
Logo MAXIM - Maxim Integrated Products

MAX9360ESA Datasheet(HTML) 7 Page - Maxim Integrated Products

  MAX9360ESA Datasheet HTML 1Page - Maxim Integrated Products MAX9360ESA Datasheet HTML 2Page - Maxim Integrated Products MAX9360ESA Datasheet HTML 3Page - Maxim Integrated Products MAX9360ESA Datasheet HTML 4Page - Maxim Integrated Products MAX9360ESA Datasheet HTML 5Page - Maxim Integrated Products MAX9360ESA Datasheet HTML 6Page - Maxim Integrated Products MAX9360ESA Datasheet HTML 7Page - Maxim Integrated Products MAX9360ESA Datasheet HTML 8Page - Maxim Integrated Products MAX9360ESA Datasheet HTML 9Page - Maxim Integrated Products  
Zoom Inzoom in Zoom Outzoom out
 7 / 9 page
background image
Detailed Description
The MAX9360/MAX9361 are low-skew, single LVTTL/
CMOS/TTL-to-differential LVECL/ECL translators
designed for high-speed signal and clock driver appli-
cations. For interfacing to LVTTL/TTL/CMOS input sig-
nals, these devices operate over a 3.0V to 5.5V supply
range, allowing high-performance clock or data distrib-
ution in systems with a nominal 3.3V or 5.0V supply. For
interfacing to differential LVECL/ECL output signals,
these devices operate from a -2.375V to -5.5V supply.
The MAX9360 is a 3.3V LVTTL/CMOS-to-LVECL/ECL
translator that operates at typical speeds of 3GHz. The
MAX9361 is a 5V TTL/CMOS-to-LVECL/ECL translator that
operates at typical speeds of 1.3GHz. Both devices can
be used to drive either LVECL devices or standard ECL
devices with a negative supply range of -2.375V to -5.5V.
Input
The MAX9360/MAX9361 inputs accept standard LVTTL/
TTL/CMOS levels. The input has pullup circuitry that dri-
ves the outputs to a differential high if the inputs are open.
Differential Output
Output levels are referenced to GND and are considered
ECL or LVECL, depending on the level of the VEE supply.
With GND connected to zero and VEE at -4.2V to -5.5V,
the outputs are ECL. The outputs are LVECL when GND is
connected to zero and VEE is at -2.375V to -3.8V.
Applications Information
Supply Bypassing
Bypass VCC and VEE to ground with high-frequency
surface-mount ceramic 0.1µF and 0.01µF capacitors in
parallel as close to the device as possible, with the
0.01µF value capacitor closest to the device. Use multi-
ple parallel vias for low inductance.
Traces
Input and output trace characteristics affect the perfor-
mance of the MAX9360/MAX9361. Connect each signal
of a differential output to a 50
Ω characteristic imped-
ance trace. Minimize the number of vias to prevent
impedance discontinuities. Reduce reflections by main-
taining the 50
Ω characteristic impedance through con-
nectors and across cables. Reduce skew within a
differential pair by matching the electrical length of the
traces.
On the MAX9360, if the input edge rate approaches the
electrical length of the interconnect, then controlled-
impedance transmission lines should be used for the
input traces.
Output Termination
Terminate outputs through 50
Ω to -2V or use an equiva-
lent Thevenin termination. Terminate both outputs and
use the same termination on each for the lowest output-
to-output skew. When a single-ended signal is taken
from a differential output, terminate both outputs. For
example, if Q is used as a single-ended output, termi-
nate both Q and Q.
Ensure that the output currents do not exceed the con-
tinuous safe output current limit or surge output current
limit as specified in the Absolute Maximum Ratings
table. Under all operating conditions, the device’s total
thermal limits should be observed.
Chip Information
TRANSISTOR COUNT: 330
PROCESS: Bipolar
LVTTL/TTL/CMOS-to-Differential LVECL/
ECL Translators
_______________________________________________________________________________________
7



Html Pages

1 2 3 4 5 6 7 8 9


Datasheet Download

Go To PDF Page


Link URL



Does ALLDATASHEET help your business so far?  [ DONATE ] 

About Alldatasheet   |   Advertisement   |   Contact us   |   Privacy Policy   |   Link to Datasheet    |   Link Exchange   |   Manufacturer List
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com