ATMEGA162 datasheet(46/323 Pages) ATMEL

46 / 323 page

ATmega162/V

2513F–AVR–12/03

System Control and

Reset

Resetting the AVR

During Reset, all I/O Registers are set to their initial values, and the program starts exe-

cution from the Reset Vector. The instruction placed at the Reset Vector must be a JMP

– Absolute Jump – instruction to the reset handling routine. If the program never

enables an interrupt source, the Interrupt Vectors are not used, and regular program

code can be placed at these locations. This is also the case if the Reset Vector is in the

Application section while the Interrupt Vectors are in the Boot section or vice versa. The

circuit diagram in Figure 21 shows the Reset Logic. Table 18 defines the electrical

parameters of the reset circuitry.

The I/O ports of the AVR are immediately reset to their initial state when a reset source

goes active. This does not require any clock source to be running.

After all reset sources have gone inactive, a delay counter is invoked, stretching the

Internal Reset. This allows the power to reach a stable level before normal operation

starts. The Time-out period of the delay counter is defined by the user through the

CKSEL Fuses. The different selections for the delay period are presented in “Clock

Sources” on page 34.

Reset Sources

The ATmega162 has five sources of reset:

•

Power-on Reset. The MCU is reset when the supply voltage is below the Power-on

Reset threshold (V

POT).

•

External Reset. The MCU is reset when a low level is present on the RESET pin for

longer than the minimum pulse length.

•

Watchdog Reset. The MCU is reset when the Watchdog Timer period expires and

the Watchdog is enabled.

•

Brown-out Reset. The MCU is reset when the supply voltage V

CC is below the

Brown-out Reset threshold (V

BOT) and the Brown-out Detector is enabled. The

device is guaranteed to operate at maximum frequency for the VCC voltage down to

BOT. VBOT must be set to the corresponding minimum voltage of the device (i.e.,

minimum V

BOT for ATmega162V is 1.8V).

•

JTAG AVR Reset. The MCU is reset as long as there is a logic one in the Reset

1149.1 (JTAG) Boundary-scan” on page 203 for details.

ATMEGA162 Datasheet(PDF) 46 Page - ATMEL Corporation

ATMEGA162 Datasheet(HTML) 46 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL