ST7FLCD1 datasheet(60/95 Pages) STMICROELECTRONICS

60 / 95 page

Display Data Channel Interfaces (DDC)

ST7FLCD1

60/95

Display Data Channel Interfaces (DDC)

11.1

Introduction

The DDC (Display Data Channel) bus interfaces are mainly used by the monitor to identify itself to

the video controller, by the monitor manufacturer to perform factory alignment, and by the user to

adjust the monitor’s parameters. Both DDC interfaces consist of:

●

A fully hardware-implemented interface, supporting DDC2B (VESA specification 3.0

compliant). It accesses the ST7 on-chip memory directly through a built-in DMA engine.

●

A second interface, supporting the slave I²C functions for handling DDC/CI mode (DDC2Bi),

factory alignment, HDCP, Enhanced DDC (EDDC) or other addresses by software.

Each DDC interface has its own dedicated DMA area in RAM. In the event of concurrent DMA

accesses, the DDC A cell has priority over the DDC B cell.

11.2

DDC Interface Features

11.2.1 Hardware DDC2B Interface Features

●

Full hardware support for DDC2B communications (VESA specification version 3)

●

Hardware detection of DDC2B addresses A0h/A1h

●

Separate mapping of EDID version 1: Base (128 bytes) and Extended (128 bytes)

●

Support for error recovery mechanism

●

Detection of misplaced Start and Stop conditions

●

Random and Sequential I²C byte read modes

●

DMA transfer from any memory location and to RAM

●

Automatic memory address increment

●

End of data downloading flag, end of communication flag and interrupt capability

11.2.2 DDC/CI Factory Interface Features

General I²C Features

●

Parallel bus /I²C protocol converter

●

Interrupt generation

●

Standard I²C mode

●

7-bit Addressing

I²C Slave Features

●

I²C bus busy flag

●

Start bit detection flag

●

Detection of misplaced Start or Stop condition

●

Transfer problem detection

●

Address Matched detection

●

2 Programmable Address detection and/or Hardware detection of DDC/CI addresses (6Eh/

6Fh)

●

End of byte transmission flag

●

Transmitter/Receiver flag

●

Stop condition Detection

ST7FLCD1 Datasheet(PDF) 60 Page - STMicroelectronics

ST7FLCD1 Datasheet(HTML) 60 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95

Datasheet Download

Link URL