LP2967 datasheet(7/20 Pages) TI1

7 / 20 page

Electrical Characteristics (Continued)

Limits in standard typeface are for T

j = 25˚C, and limits in boldface type apply over the full operating junction temperature

range. Unless otherwise specified, V

IN =VO(NOM) + 1V, IL = 1mA, CIN = 1µF,COUT = 4.7µF, VON/OFF = 1.6V.

Symbol

Parameter

Conditions

Min

Typ

Max

Units

Ripple Rejection

BYPASS = 100nF, VIN =

O(NOM) + 1V + 100mV p-p

square wave (trise and tfall =

100ns)

−52

−54

−56

−58

−50

−47

−70

F = 120Hz

F = 800Hz

F = 1000Hz

F = 1600Hz

F = 10kHz

F = 100kHz

F = 1MHz

Xtalk

Crosstalk

Rejection

∆I

LOAD 1 = 150 mA at 1kHz rate

(15 mA/µs rise and fall slope)

LOAD2 = 1mA

∆V

OUT 2/

∆V

OUT 1

−100

∆I

LOAD 2 = 150 mA at 1KHz rate

(15 mA/µs rise and fall slope)

−100

LOAD 1 = 1mA

∆V

OUT 2/

∆V

OUT 1

Note 1: Absolute maximum ratings indicate limits beyond which damage to the device may occur. Electrical specifications do not apply when operating the device

beyond its rated operating conditions.

Note 2: Rating is for the human body mode, a 100pF capacitor discharged through a 1.5k

Ω resistor into each pin.

Note 3: The maximum allowable power dissipation is calculated by using PDMAX =(TJMAX -TA/θJA, where TJMAX is the maximum junction temperature, TA is the

ambient temperature, and

θJA is the junction-to-ambient thermal resistance of the specified package. Therefore, the maximum power dissipation must be derated

at elevated temperatures and is limited by TJMAX, θJA and A.

Note 4: If used in a dual-supply system where the regulator load is returned to a negative supply, the LP2967 output must be diode-clamped to ground.

Note 5: The output PNP structure contains a diode between the VIN and VOUT terminals that is normally reverse-biased. Reversing the polarity from VIN and VOUT

will turn on this diode.

Note 6: Load regulation excursion over temperature is included in Output Voltage Tolerance.

Note 7: The dropout voltage of a regulator is defined as the minimum input-to-output differential required to stay within 100mV of the output voltage measured with

a 1V differential.

LP2967 Datasheet(PDF) 7 Page - Texas Instruments

LP2967 Datasheet(HTML) 7 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Datasheet Download

Link URL