CN-0287

Circuit Note

Rev. C | Page 8 of 9

Test

Launch the evaluation software. After USB communications are

established, the SDP-B board can be used to send, receive, and

capture data from the EVAL-CN0287-SDPZ board.

Figure 11 shows a photo of the EVAL-CN0287-SDPZ evaluation

board connected to the SDP board. Information regarding the

SDP-B board can be found in the SDP-B User Guide.

Information and details regarding test setup and calibration,

and how to use the evaluation software for data capture can be

found in the CN-0287 Software User Guide.

Connectivity for Prototype Development

The EVAL-CN0287-SDPZ evaluation board is designed to use

the EVAL-SDP-CB1Z SDP-B board; however, any

microprocessor can be used to interface to the SPI interface

through the PMOD connector J6. The pin definition of PMOD

connector can be found in the schematics of CN0287 evaluation

board in CN-0287 Design Support Package. In order for

another controller to be used with the EVAL-CN0287-SDPZ

evaluation board, software must be developed by a third party.

Figure 11. EVAL-CN0287-SDPZ Evaluation Board Connected to the EVAL-SDP-CB1Z SDP-B Board