AND8090 datasheet(13/20 Pages) ONSEMI

13 / 20 page

AND8090/D

http://onsemi.com

Negative Setup and Positive Hold Example – The

MC100E445 4−Bit Serial/Parallel Converter data sheet

specifies the following:

• The minimum setup time of negative 200 ps indicates

that the left edge of the timing window is 200 ps after

the active rising clock edge.

• The minimum hold time of positive 300 ps specifies

that the right edge of the timing window is 300 ps after

the active rising clock edge.

The setup time requirement and the hold time requirement

were both met in the example shown in Figure 33, therefore

the LOW−to−HIGH output transition occurs after the CLK

rising edge propagation delay of 1800 ps. Note that the input

cannot change within the timing window of 100 ps. Only

one of the differential clocks and differential inputs is shown

in Figure 33.

Positive Setup and Negative Hold Example – The

MC100E136 6−Bit Universal Up/Down Counter data sheet

specifies the following:

• The minimum setup time of positive 400 ps indicates

that the left edge of the timing window is 400 ps before

the active rising clock edge.

• The minimum hold time of negative 250 ps specifies

that the right edge of the timing window is 250 ps

before the active rising clock edge.

The setup time requirement and the hold time requirement

were both met in the example shown in Figure 34, therefore

the LOW−to−HIGH output transition occurs after the CLK

rising edge propagation delay of 1150 ps. Note that the input

cannot change within the timing window of 150 ps.

Figure 33. Negative Setup and Positive Hold Example

t(ps)

CLK

50%

50% 50%

INPUT

OUTPUT

tPLH

1800 ps

−200

ts(min)

+300

th(min)

50%

Figure 34. Positive Setup and Negative Hold Example

t(ps)

CLK

50%

INPUT

OUTPUT

tPLH

1150 ps

+400

ts(min)

−250

th(min)

50%

AND8090 Datasheet(PDF) 13 Page - ON Semiconductor

AND8090 Datasheet(HTML) 13 Page - ON Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Datasheet Download

Link URL