ST7MC-KIT/BLDC

Starter kit architecture

Doc ID 11587 Rev 2

3/5

1.4

STXF-INDART/USB

In-circuit debugging and in-circuit programming tool that provides the hardware interface

with the host PC via USB and with your ST7FMC via 10-pin in-circuit communication (ICC)

connection.

1.5

STVD7 for inDART

Integrated development environment for writing, building and debugging your application.

1.6

Optoisolation board

Board with two 10-pin ICC connectors (In/Out) provides galvanic isolation between the in-

circuit debugging/programming tool and any target board supplied by high voltage. It is

included with the motor control starter kit, or can be ordered separately (ST ordering code:

ST7-ICC/OPTOISOL).

1.7

Induction motor

240V/800W Selni three-phase induction motor for use with the motor control starter kit using

induction motor default values (for evaluation purposes). It is not included with the kit, but

can be ordered separately (ST ordering code: ST7MC-MOT/IND).