For this example, we’ve got a sub-micro servo motor and a common anode

RGB LED connected to the PWM block outputs. We’ve closed the

VSYS->VIN jumper with a solder blob, so we’re drawing power from the

Edison’s supply. For a larger servo motor or more LEDs, you should open

that jumper, and connect an external supply to the VIN and GND pads at

the end of the header.

Of course, you can connect any other device to the outputs here – the

PWM input to a motor driver, a buzzer, what have you. We just want to

demonstrate the core capabilities of this block, which is to provide servo

driving and visually normalized LED outputs.

Code

Everything you need to know is in the comments.

Page 4 of 9