DS1670

6 of 17

AIS0-AIS1 (Analog Input Select) - These 2 bits are used to determine the analog input for the analog-to-

digital conversion. Table 2 lists the specific analog input that is selected by these two bits.

AIE (Alarm Interrupt Enable) - When set to a logic 1, this bit permits the Interrupt Request Flag

(IRQF) bit in the status register to assert INT. When the AIE bit is set to logic 0, the IRQF bit does not

initiate the INT signal.

ANALOG INPUT SELECTION Table 2

AIS1

AIS0

ANALOG INPUT

0

0

NONE

01

AIN0

10

AIN1

11

AIN2

STATUS REGISTER

BIT 7

BIT 6

BIT 5

BIT 4

BIT 3

BIT 2

BIT 1

BIT 0

CU

LOBAT

0

00

00

IRQF

CU (Conversion Update In Progress) - When this bit is a 1, an update to the ADC Register (register

0Eh) will occur within 488 ms. When this bit is a 0, an update to the ADC Register will not occur for at

least 244 ms.

LOBAT (Low Battery Flag) - This bit reflects the status of the backup power source connected to the

volts, LOBAT is set to a logic 1.

IRQF (Interrupt Request Flag) - A logic 1 in the Interrupt Request Flag bit indicates that the current

time has matched the time of day Alarm registers. If the AIE bit is also a logic 1, the INT pin will go

high. IRQF is cleared by reading or writing to any of the alarm registers.

POWER-UP DEFAULT STATES

These bits are set to a one upon initial power-up:

EOSC , TD1 and TD0. These bits are cleared upon

initial power-up: WP, AIS1, and AIS0.

NONVOLATILE SRAM CONTROLLER

The DS1670 provides automatic backup and write protection for external SRAM. This function is

pin. The DS1670 was specifically designed with the Intel 80186 and 386EX microprocessors in mind.

As such, the DS1670 has the capability to provide access to the external SRAM in either byte-wide or

word-wide format. This capability is provided by the chip enable scheme. Three input signals and two

function of these pins.