PICDEM2 datasheet(10/60 Pages) MICROCHIP

10 / 60 page

 2001 Microchip Technology Inc.

DS30374D-page 5

PICDEM 2 USER’S GUIDE

Chapter 2. Getting Started

The PICDEM 2 may be used as a stand-alone board or with an emulator. For

a list of PICmicro® 8-bit microcontroller-compatible emulators, please refer to

the Microchip Third Party Guide or the Development Systems Ordering

Guide.

2.1 PICDEM 2 as a Stand-alone Board –

Preprogrammed Device

The PICDEM 2 may be demonstrated immediately by following the steps

listed below:

• Make sure the pre-programmed sample device is in the appropriate

socket on the PICDEM 2 board.

• Make sure there are jumpers on J6 (to enable the LEDs) and J7 (to

enable the on-board RC oscillator).

• Apply power to the PICDEM 2 (Figure 2.1). For information on accept-

able power sources, see Appendix A.

• Press push-button S2 repeatedly to see the LEDs count up from 00h to

FFh. Press push-button S1 to reset.

Figure 2.1: PICDEM 2 Stand-Alone

Power Supply

PICDEM 2 Demo Board

Sample

Device

(not included)

PICDEM2 Datasheet(PDF) 10 Page - Microchip Technology