PICDEM2 datasheet(12/60 Pages) MICROCHIP

12 / 60 page

 2001 Microchip Technology Inc.

DS30374D-page 7

Getting Started

2.2.2.

Reprogramming the Sample Device

To reprogram the erased sample device, the following will be necessary:

Sample programs installed on the hard drive.

The PICDEM 2 package includes a 3.5-inch disk which contains sample

programs for all the processor types supported. Instructions on how to

install the programs can be found in the readme file also on the disk.

An assembler, such as MPASM available with MPLAB IDE.

Sample programs may be used to program the sample device once they

have been assembled. Microchip Technology’s MPLAB Integrated Devel-

opment Environment includes an assembler (MPASM). However, other

assemblers may be used. For a list of PICmicro-compatible assemblers,

please refer to the Microchip Third Party Handbook.

A device programmer, such as PRO MATE II or PICSTART Plus.

Once the sample program is in hex file format, a programmer may be used

to program a blank device. Microchip Technology’s PRO MATE II or

PICSTART Plus programmers may be used. Both are compatible with

MPLAB. However, other programmers may be used. For a list of PICmicro-

compatible programmers, please refer to the Microchip Third Party Guide.

If the code protection bit(s) have not been programmed, the on-chip program

memory can be read out for verification purposes.

Note:

Microchip does not recommend code protecting windowed

devices.

PICDEM2 Datasheet(PDF) 12 Page - Microchip Technology