LTC3404 datasheet(13/16 Pages) LINER

13 / 16 page

LTC3404

A second, more severe transient is caused by switching in

loads with large (>1

µF) supply bypass capacitors. The

discharged bypass capacitors are effectively put in parallel

with COUT, causing a rapid drop in VOUT. No regulator can

deliver enough current to prevent this problem if the load

switch resistance is low and it is driven quickly. The only

solution is to limit the rise time of the switch drive so that

the load rise time is limited to approximately (25 • CLOAD).

Thus, a 10

µF capacitor charging to 3.3V would require a

250

µs rise time, limiting the charging current to about

130mA.

PC Board Layout Checklist

When laying out the printed circuit board, the following

checklist should be used to ensure proper operation of the

LTC3404. These items are also illustrated graphically in

the layout diagram of Figure 7. Check the following in your

layout:

1. Are the signal and power grounds segregated? The

LTC3404 signal ground consists of the resistive

divider, the optional compensation network (RC and

CC1) and CC2. The power ground consists of the (–)

plate of CIN, the (–) plate of COUT and Pin 4 of the

LTC3404. The power ground traces should be kept

short, direct and wide. The signal ground and power

ground should converge to a common node in a star-

ground configuration.

2. Does the VFB pin connect directly to the feedback

resistors? The resistive divider R1/R2 must be con-

nected between the (+) plate of COUT and signal ground.

3. Does the (+) plate of CIN connect to VIN as closely as

possible? This capacitor provides the AC current to the

internal power MOSFETs.

4. Keep the switching node SW away from sensitive small

signal nodes.

Design Example

As a design example, assume the LTC3404 is used in a

single lithium-ion battery-powered cellular phone applica-

tion. The input voltage will be operating from a maximum

of 4.2V down to about 2.7V. The load current requirement

is a maximum of 0.3A but most of the time it will be in

standby mode, requiring only 2mA. Efficiency at both low

and high load currents is important. Output voltage is

2.5V. With this information we can calculate L using

equation (1),

OUT

= () ∆()

−









(3)

Substituting VOUT = 2.5V, VIN = 4.2V, ∆IL=120mA and

f = 1.4MHz in equation (3) gives:

MHz

=−









=µ

1 4

120

)

A 6.2

µH inductor works well for this application. For best

efficiency choose a 1A inductor with less than 0.25

Ω

series resistance.

CIN will require an RMS current rating of at least 0.15A at

temperature and COUT will require an ESR of less than

0.25

Ω. In most applications, the requirements for these

capacitors are fairly similar.

For the feedback resistors, choose R1 = 412k. R2 can

then be calculated from equation (2) to be:

k use

OUT

1 875 5

=−









;

87k

Figure 8 shows the complete circuit along with its effi-

ciency curve.

APPLICATIO S I FOR ATIO

LTC3404 Datasheet(PDF) 13 Page - Linear Technology

LTC3404 Datasheet(HTML) 13 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datasheet Download

Link URL