3

Assembly Instruction

Assembly Instructions

1. TRIM CABLE AS SHOWN ABOVE. TIN END OF CENTER CONDUCTOR.

2. SLIDE CRIMP SLEEVE AND SHRINK TUBE (IF SUPPLIED) OVER CABLE JACKET.

3. FLARE CABLE BRAID OUT SLIGHTLY BY ROTATING DIELECTRIC.

4. INSERT CABLE ASSEMBLY INTO BODY TAIL-END MAKING SURE TAIL GOES OVER

DIELECTRIC AND UNDER BRAID. SLIDE IN UNTIL BRAID TOUCHES REAR SURFACE OF

BODY.

5. SLIDE CRIMP SLEEVE FORWARD AND USE .105 HEX DIE TO CRIMP SLEEVE TO BRAID.

6. SOLDER CENTER CONDUCTOR OF CABLE TO CONTACT.

7. PLACE INSULATOR AND END CAP INTO CONNECTOR BODY AS SHOWN AND USE

A .185” DIAMETER FLAT BOTTOM PUNCH TO PRESS CAP IN PLACE. CAP MUST BE

BELOW SURFACE TO SEAT PROPERLY.

8. SLIDE SHRINK TUBE (IF SUPPLIED) OVER CRIMP SLEEVE AND SHRINK TO FIT.

PE45381 REV 1.0

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,

inventory and certifications: SSMC Plug Right Angle Connector Crimp/Solder Attachment for RG178, RG196 PE45381

RF Connectors Technical Data Sheet

PE45381

SSMC Plug Right Angle Connector Crimp/

Solder Attachment for RG178, RG196