Electrical Characteristics V

The following specifications apply for the circuit shown in Figure 2, unless otherwise specified. A

Ω.

Limits apply for T

Symbol

Parameter

Conditions

LM4924

Units

(Limits)

Typical

Limit

(Note 6)

(Note 7)

THD

P

0.1

%

Crosstalk

Freq = 1kHz

45

dB (min)

PSRR

Power Supply Rejection Ratio

V

Freq = 100Hz, OCL

66

dB

Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is

functional, but do not guarantee specific performance limits. Electrical Characteristics state DC and AC electrical specifications under particular test conditions which

guarantee specific performance limits. This assumes that the device is within the Operating Ratings. Specifications are not guaranteed for parameters where no limit

is given, however, the typical value is a good indication of device performance.

Absolute Maximum Ratings section.

Note 3: Human body model, 100pF discharged through a 1.5k

Ω resistor.

Note 4: Machine model, 220pF–240pF discharged through all pins.

Note 5: All voltages are measured with respect to the ground (GND) pins unless otherwise specified.

Note 6: Typicals are measured at 25˚C and represent the parametric norm.

Note 7: Datasheet min/max specification limits are guaranteed by design, test, or statistical analysis.

Note 8: The quiescent power supply current depends on the offset voltage when a practical load is connected to the amplifier.

Note 9: Output power is measured at the device terminals.

www.national.com

5