SQ-PTS

Updated: 2014-01-16

© SignalQuest, LLC.

1999-2014

10 Water St.

Lebanon, NH 03766 USA

Tel: 603.448.6266

Fax 603.619.6330

www.signalquest.com

info@signalquest.com

5

1

GND

2

NC

Solder to open circuit for mechanical stability. Do not connect to GND.

3

NC

Solder to open circuit for mechanical stability. Do not connect to GND.

4

Logic

Digital Input – High (or open) selects Active High logic output on triggers, Low selects

Active Low logic output on triggers. Solder to open circuit for mechanical stability if not

used. Do not connect to GND.

5

+Vcc

6

XTrigger 1

Digital Output - Transitions logic level when trigger threshold is exceeded. Configure

Logic pin to set this as HighLow or LowHigh. Solder to open circuit for mechanical

stability if not used. Do not connect to GND. High output impedance.

7

YTrigger 2

Digital Output - Transitions logic level when trigger threshold is exceeded. Configure

Logic pin to set this as HighLow or LowHigh. Solder to open circuit for mechanical

stability if not used. Do not connect to GND. High output impedance.

8

Dual Axis Tilt Mode

/ Single Axis

Gimbaled Mode

Select

Digital Input – High (or open) selects Dual Axis Tilt Mode (D), Low selects Single Axis

Gimbaled Mode (S). If not used, solder to open circuit for mechanical stability.

9

Zero Set

Digital Input – Transition from HighLow sets zero position and saves to non-volatile

memory. Solder to open circuit for mechanical stability if not used. Do not connect to

GND.

10

NC

Solder to open circuit for mechanical stability. Do not connect to GND

11

XTrigger 3

Digital Output - Transitions logic level when trigger threshold is exceeded. Configure

Logic pin to set this as HighLow or LowHigh. Solder to open circuit for mechanical

stability if not used. Do not connect to GND. Low output impedance.

12

YTrigger 4

Digital Output - Transitions logic level when trigger threshold is exceeded. Configure

Logic pin to set this as HighLow or LowHigh. Solder to open circuit for mechanical

stability if not used. Do not connect to GND. Low output impedance.

13

NC

Solder to open circuit for mechanical stability. Do not connect to GND.

14

NC

Solder to open circuit for mechanical stability. Do not connect to GND.

15

/Reset & Prog 1

Digital Input – Active low reset. Bring low for >10 mS to reset device. If not used, solder

to open circuit for mechanical stability. Do not connect to GND. Also used for FLASH

programming.

16

Prog 2

Digital Input – If not used, solder to open circuit for mechanical stability. Do not connect to

GND. Also used for FLASH programming.

17

NC

Solder to open circuit for mechanical stability. Do not connect to GND.

18

NC

Solder to open circuit for mechanical stability. Do not connect to GND.

*Note: Grey boxes indicate a function is available only on a custom application basis. NC means “no connection”.