LM25005 datasheet(12/21 Pages) NSC

12 / 21 page

Oscillator and Sync Capability (Continued)

Error Amplifier and PWM

Comparator

The internal high gain error amplifier generates an error

signal proportional to the difference between the regulated

output voltage and an internal precision reference (1.225V).

The output of the error amplifier is connected to the COMP

pin allowing the user to provide loop compensation compo-

nents, generally a type II network, as illustrated in Figure 1.

This network creates a pole at DC, a zero and a noise

reducing high frequency pole. The PWM comparator com-

pares the emulated current sense signal from the RAMP

generator to the error amplifier output voltage at the COMP

pin.

RAMP Generator

The ramp signal used in the pulse width modulator for cur-

rent mode control is typically derived directly from the buck

switch current. This switch current corresponds to the posi-

tive slope portion of the output inductor current. Using this

signal for the PWM ramp simplifies the control loop transfer

function to a single pole response and provides inherent

input voltage feed-forward compensation. The disadvantage

of using the buck switch current signal for PWM control is the

large leading edge spike due to circuit parasitics that must

be filtered or blanked. Also, the current measurement may

introduce significant propagation delays. The filtering, blank-

ing time and propagation delay limit the minimum achievable

pulsewidth. In applications where the input voltage may be

relatively large in comparison to the output voltage, control-

ling small pulsewidths and duty cycles is necessary for regu-

lation. The LM25005 utilizes a unique ramp generator, which

does not actually measure the buck switch current but rather

reconstructs the signal. Reconstructing or emulating the in-

ductor current provides a ramp signal to the PWM compara-

tor that is free of leading edge spikes and measurement or

filtering delays. The current reconstruction is comprised of

two elements; a sample & hold DC level and an emulated

current ramp.

20170007

FIGURE 5. Simplified Oscillator Block Diagram and SYNC I/O Circuit

LM25005 Datasheet(PDF) 12 Page - National Semiconductor (TI)