MPC8535EEC datasheet(89/127 Pages) NXP

89 / 127 page

Electrical Characteristics

MPC8535E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 7

Freescale Semiconductor

This figure provides the AC test load for PCI.

Figure 54. PCI AC Test Load

This figure shows the PCI input AC timing conditions.

Figure 55. PCI Input AC Timing Measurement Conditions

HRESET high to first FRAME assertion

tPCRHFV

—

clocks

Rise time (20%–80%)

tPCICLK

0.6

2.1

—

Failing time (20%–80%)

tPCICLK

0.6

2.1

—

Notes:

1. The symbols used for timing specifications herein follow the pattern of t(first two letters of functional block)(signal)(state) (reference)(state)

for inputs and t(first two letters of functional block)(reference)(state)(signal)(state) for outputs. For example, tPCIVKH symbolizes PCI timing

(PC) with respect to the time the input signals (I) reach the valid state (V) relative to the SYSCLK clock, tSYS, reference (K)

going to the high (H) state or setup time. Also, tPCRHFV symbolizes PCI timing (PC) with respect to the time hard reset (R) went

high (H) relative to the frame signal (F) going to the valid (V) state.

2. See the timing measurement conditions in the PCI 2.2 Local Bus Specifications.

3. All PCI signals are measured from OVDD/2 of the rising edge of PCI_SYNC_IN to 0.4 × OVDD of the signal in question for 3.3-V

PCI signaling levels.

4. For purposes of active/float timing measurements, the Hi-Z or off state is defined to be when the total current delivered through

the component pin is less than or equal to the leakage current specification.

5. Input timings are measured at the pin.

6. The timing parameter tSYS indicates the minimum and maximum CLK cycle times for the various specified frequencies. The

system clock period must be kept within the minimum and maximum defined ranges. For values see Section 22, “Clocking.”

7. The setup and hold time is with respect to the rising edge of HRESET.

8. The timing parameter tPCRHFV is a minimum of 10 clocks rather than the minimum of 5 clocks in the PCI 2.2 Local Bus

Specifications.

9. The reset assertion timing requirement for HRESET is 100

μs.

Table 68. PCI AC Timing Specifications at 66 MHz (continued)

Parameter

Symbol 1

Min

Max

Unit

Notes

Output

Z0 = 50 Ω

OVDD/2

RL = 50 Ω

tPCIVKH

CLK

Input

tPCIXKH

MPC8535EEC Datasheet(PDF) 89 Page - NXP Semiconductors

MPC8535EEC Datasheet(HTML) 89 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL