Unless otherwise noted: T

for Min and Max parameters and (Note 6) for Typicals.

Symbol

Parameter

Conditions

Min

Typ

Max

Units

I

L

Logic low input current

(SCL, SDA, HSYNC, VSYNC)

SDA or SCL, Input Voltage = 0V

µA

I

H

Logic high input current

(SCL, SDA, HSYNC, VSYNC)

SDA or SCL, Input Voltage = 5.0V

µA

V

OL

Logic low output voltage (SCL,

SDA)

I

0.5

V

I

FB THRESHOLD

I

24)

−20

µA

I

FB IN MAX

Flyback input

Absolute maximum current during

flyback

5mA

I

FB IN MAX

Peak flyback input current

Design value - AC coupled

1.0

mA

I

FB OUT MAX

Flyback input current

Absolute maximum during scan

−500

µA

t

H-BLANK ON

Blanking time delay - on

+ Zero crossing of I

output blanking start. I

50

ns

t

H-BLANK OFF

Blanking time delay - off

− Zero crossing of I

output blanking end. I

50

ns

V

BLANK MAX

Maximum video blanking level

CONTRAST[6:0], RGAIN[6:0],

GGAIN[6:0], BGAIN[6:0] = 0x7F,

BRIGHTNESS[7:0] = 0x00,

OFFSET[3:0] = 0xC, AC input

signal.

0

0.25

V

t

PW CLAMP

Minimum clamp pulse width

See (Note 15)

200

ns

V

CLAMP MAX

Maximum low level clamp voltage

To guarantee low state

1.0

V

V

CLAMP MIN

Minimum high level clamp voltage

To guarantee high state

3.0

V

I

CLAMP LOW

Clamp gate low input current

V

−0.4

µA

I

CLAMP HIGH

Clamp gate high input current

V

0.4

µA

t

CLAMP-VIDEO

Minimum wait from end of clamp

pulse to start of video.

Referenced to RGB video inputs.

50

ns

V

HEHT-LOW

Low limit of pin 20 HEHT input

1.4

V

V

HEHT-HIGH

High limit of pin 20 HEHT input

3.4

V

V

V

VEHT2-LOW

Low limit of pins 8 and 9 VEHT

inputs

1V

V

VEHT1-HIGH,

V

VEHT2-HIGH

High limit of pins 8 and 9 VEHT

inputs

4V

Note 1: Limits of Absolute Maximum Ratings indicate below which damage to the device will not occur.

Note 2: All voltages are measured with respect to GND, unless otherwise specified.

Note 3: Operating Ratings indicate conditions for which the device is functional, but do not guarantee specific performance limits.

Note 4: Human body model, 100 pF discharged through a 1.5 k

Ω resistor.

Note 6: Typical specifications are specified at +25˚C and represent the most likely parametric norm.

Note 7: Datasheet min/max specification limits are guaranteed by design, test, or statistical analysis. The guaranteed specifications apply only for the test conditions

listed. Some performance characteristics may change when the device is not operated under the listed test conditions.

therefore all the supply current is used by the pre-amp.

with each at least 100 ns in duration.

Note 11:

Note 12: The ABL input provides smooth decrease in gain over the operational range of 0 dB to −5 dB:

the gain characteristics, linearity and pulse response may depart from normal values.

www.national.com

7