VS6524 datasheet(14/70 Pages) STMICROELECTRONICS

14 / 70 page

Operational modes

VL6524/VS6524

14/70

During the power-up sequence (CE = logic 1)

●

The digital supplies must be on and stable.

●

The internal digital supply of the VL6524/VS6524 is enabled by an internal switch

mechanism.

●

All internal registers are reset to default values by an internal power on reset cell.

Figure 3.

Power up sequence

STANDBY mode: The VL6524/VS6524 enters STANDBY mode when the CE pin on the

device is pulled HIGH. Power consumption is very low, most clocks inside the device are

switched off.

In this state I²C communication is possible when CLK is present and when the

microprocessor is enabled by writing the value 0x06 to the

MicroEnable register 0xC003

(

Table 7).

All registers are reset to their default values. The device I/O pins have a very high-

impedance.

Note:

On exit from STANDBY mode, the VL6524/VS6524 is in a transient mode called

UNINITIALISED, this mode is not a user mode.

STOP mode: This is a low power mode. The analogue section of the VL6524/VS6524 is

switched off and all registers are accessed over the I²C interface. A run command received

in this state automatically sets a transition through the PAUSE state to the run mode.

PAUSE mode: In this mode all VL6524/VS6524 clocks are running and all registers are

accessible but no data is output from the device. The device is ready to start streaming but

is halted. This mode is used to set up the required output format before outputting any data.

Note:

The PowerManagement register bTimeToPowerdown can be adjusted in PAUSE mode but

has no effect until the next RUN to PAUSE transition (Table 13).

RUN mode:This is the fully operational mode.

CLK

AVDD (2.8V)

VDD (1.8V/2.8V)

SDA

SCL

t1 >= 0ns

t2 >= 0ns

t3 >= 0ns

t4 >= 25ms

Constraints:

low level command:enable clocks

setup commands

t5 >= 2ms

standby

POWER DOWN

VS6524 Datasheet(PDF) 14 Page - STMicroelectronics

VS6524 Datasheet(HTML) 14 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70

Datasheet Download

Link URL