WM8980_07 datasheet(43/112 Pages) WOLFSON

43 / 112 page

Pre-Production

WM8980

PP Rev 3.1 March 2007

Figure 21 DAC Digital Filter Path

The analogue outputs from the DACs can then be mixed with the aux analogue inputs and the ADC

analogue inputs. The mix is fed to the output drivers for headphone (LOUT1/ROUT1), speaker

(LOUT2/ROUT2) or line (OUT3/OUT4). OUT3 and OUT4 have additional mixers which allow them

to output different signals to the headphone and speaker outputs.

DIGITAL PLAYBACK (DAC) PATH

Digital data is passed to the WM8980 via the flexible audio interface and is then passed through a

variety of advanced digital filters (as shown in Figure 21) to the hi-fi DACs. The DACs are enabled

by the DACENL/R register bits.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

DACENL

Left channel DAC enable

0 = DAC disabled

1 = DAC enabled

Power

Management 3

DACENR

Right channel DAC enable

0 = DAC disabled

1 = DAC enabled

Table 22 DAC Enable Control

The WM8980 also has a Soft Mute function, which, when enabled, gradually attenuates the volume

of the digital signal to zero. When disabled, the gain will ramp back up to the digital gain setting. This

function is enabled by default. To play back an audio signal, this function must first be disabled by

setting the SOFTMUTE bit to zero.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

DACPOLL

Left DAC output polarity:

0 = non-inverted

1 = inverted (180 degrees phase shift)

DACPOLR

Right DAC output polarity:

0 = non-inverted

1 = inverted (180 degrees phase shift)

AMUTE

Automute enable

0 = Amute disabled

1 = Amute enabled

DACOSR128

DAC oversampling rate select:

0=64x (lowest power)

1=128x (best SNR)

R10

DAC Control

SOFTMUTE

Softmute enable:

0=Enabled

1=Disabled

Table 23 DAC Control Register

The digital audio data is converted to oversampled bit streams in the on-chip, true 24-bit digital

interpolation filters. The bitstream data enters the multi-bit, sigma-delta DACs, which convert it to a

high quality analogue audio signal. The multi-bit DAC architecture reduces high frequency noise and

sensitivity to clock jitter. It also uses a Dynamic Element Matching technique for high linearity and

low distortion.

WM8980 Datasheet(PDF) 43 Page - Wolfson Microelectronics plc

WM8980 Datasheet(HTML) 43 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL