2

738A INSTALLATION GUIDE

|

DIGITAL MONITORING PRODUCTS

3ProgrammingOptions

Use this section for reference when programming the module.

INIT ALL?

NO YES

INITIALIZATION

Select

YES to reset all programming options to the factory default. Select NO to

maintain all programming options at their current settings.

BUS:

*KYPD

LX

PANEL BUS TYPE

Select the type of connection from the panel to the module. Choose either Keypad

Bus or LX‑Bus connection. Press the

CMD key to accept the selection. An asterisk

displays to the left of the bus type selected.

Note: If the 738A will be used on the keypad bus, ensure it is programmed as a

device in

Device Setup.

HOUSE ID:

01

HOUSE ID

Select a number from 01 to 31 for the House ID. Enter a leading zero for numbers

less than ten. The factory default is

01. The same House ID number must be

programmed into any 5804BD Wireless Key transmitters to receive Armed, Alarm,

and Ready to Arm status. Refer to the Ademco 5804BD Installation Instructions to

enter the House ID.

ZONE? TEST ADD

ZONE TEST OR ADD

Select

ADD to program new zones into the system or select TEST to perform a zone

test on existing zones. When performing a Zone Test, the 5881 receiver signal gain is

reduced by 50%. When adding new zones to the system, select

TEST to perform the

Zone Test.

TRIPS

END

ZONE TEST TRIPS COUNTER

When

TEST is selected, the Zone Test Trips Counter displays the number of times

any programmed zone trips (alarm/short) during the Zone Test. The keypad buzzer

sounds for 1 second each time a programmed zone trips. Select

END to stop the

zone test and display any failed zones.

Note: When the keypad is removed from the module, the 5881 receiver signal

gain automatically returns to 100%.

ZONE: XX

‑FAIL

ZONE TEST FAIL

The zone number of any zone that failed to trip at least once during the test

displays for four seconds and the buzzer sounds for one second. The next failed

zone displays. Press

CMD to advance to the next failed zone.

PROGRAM THE MODULE

DMP

BUS

Ademco Reciever

Model 738A

PROG

RECEIVER

Model 330

Programming

Harness

PROGRAM

5800TM Transmitter

To Keypad Bus

or LX Bus

Model 300

4-Wire Harness

To Keypad

DMP Model 300

Wire Color

Ademco Harness

Wire Color

Red

Red

Yellow

Yellow

Green

Green

Black

Black

N/A

Blue

Figure 4: 738A Wiring