CE6353

Data Sheet

19

Intel Corporation

3.2.2

MPEG Data Output Signals

The MPEGEN bit in the CONFIG register must be set low to enable the MPEG data. The maximum movement in

the packet synchronization byte position is limited to ±1 output clock period. MOCLK will be a continuously running

clock once symbol lock has been achieved, and is derived from the symbol clock. MOCLK is shown in Figure 7 with

MOCLKINV = ‘1’, the default state, see register 0x50.

All output data and signals (MDO[7:0], MOSTRT, MOVAL & BKERR) change on the negative edge of MOCLK

(MOCLKINV = 1) to present stable data and signals on the positive edge of the clock.

A complete packet is output on MDO[7:0] on 188 consecutive clocks and the MDO[7:0] pins will remain low during

the inter-packet gaps. MOSTRT goes high for the first byte clock of a packet. MOVAL goes high on the first byte of

a packet and remains high until the last byte has been clocked out. BKERR goes low on the first byte of a packet

where uncorrectable bytes are detected and will remain low until the last byte has been clocked out.

Figure 7 - MPEG Output Data Waveforms

3.2.3

MPEG Output Timing

MOCLK frequency = 45.06 MHz.

MDO7:0

MOCLKINV=1

MOCLK

MOSTRT

MOVAL

BKERR

Tp

Ti

1st byte packet n

188 byte packet n

1st byte packet n+1