| Electronic Components Datasheet Search |
|
PR31700 Datasheet(PDF) 21 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
PR31700 Datasheet(HTML) 21 Page - NXP Semiconductors |
|
21 / 36 page ![]() Philips Semiconductors Preliminary specification PR31700 32-bit RISC microprocessor 1998 May 13 21 PERIPHERAL FUNCTIONS CLOCK GENERATOR The PR31700 uses an internal PLL and an external crystal oscillator to generate a clock with eight times the input clock frequency. The PLL oscillation can be halted externally to reduce power dissipation. WRITE BUFFER The PR31700 incorporates a four-stage write buffer. BUS INTERFACE UNIT (BIU) MODULE The PR31700 has a Bus Interface Unit with the following features. • supports 2 Banks of SDRAM and/or DRAM / HDRAM – 8-bit or 16-bit SDRAM configuration – 16-bit or 32-bit DRAM configuration – 16-bit or 32-bit HDRAM configuration – 4 Mbit, 16 Mbit and 64 Mbit parts supported – page mode reads and writes supported – independent refresh counters for each bank – self refreshing parts supported to retain memory when system is powered down • 4 general purpose chip selects (CS3*–CS0*) – 16-bit or 32-bit ports – programmable wait states – read page mode • 4 general purpose chip selects (MCS3*–MCS0*) – 16-bit ports – programmable wait states – read page mode • 2 full PCMCIA slots – 16-bit ports – IORD and IOWR provided to support I/O cards – WAIT signal supported SYSTEM INTERFACE UNIT (SIU) MODULE The PR31700 has a System Interface Unit with the following features. • multi-channel 32-bit DMA controller • independent DMA controller for video, SIB to/from BETTY audio/telecom codecs, high-speed serial port, IR, UART, and general purpose UART • address decoding for the internal registers CLOCK MODULE The PR31700 has a Clock Module with the following features. • The PR31700 supports system-wide single crystal configuration, besides the 32 kHz RTC XTAL (reduces cost, power, and board space) • common crystal rate divided to generate clock for CPU, video, sound, telecom, UARTs, etc. • independent enabling or disabling of individual clocks under software control, for power management CONCENTRATION HIGHWAY INTERFACE (CHI) MODULE The PR31700 has a CHI Module with the following features. • high-speed serial Concentration Highway Interface (CHI) contains logic for interfacing to external full-duplex serial time-division-multiplexed (TDM) communication peripherals • supports ISDN line interface chips and other PCM/TDM serial devices • CHI interface is programmable (number of channels, frame rate, bit rate, etc.) to provide support for a variety of formats • supports data rates up to 4.096 Mbps • independent DMA support for CHI receive and transmit INTERRUPT MODULE The PR31700 has an Interrupt Module with the following features. • contains logic for individually enabling, reading, and clearing all PR31700 interrupt sources • interrupts generated from internal PR31700 modules or from edge transitions on external signal pins IO MODULE The PR31700 has an IO Module with the following features. • contains support for reading and writing the 7 bi-directional general purpose IO pins and the 32 bi-directional multi-function IO pins • each IO port can generate a separate positive and negative edge interrupt • independently configurable IO ports allow the PR31700 to support a flexible and wide range of system applications and configurations IR MODULE The PR31700 has an IR Module with the following features. • IR consumer mode – allows control of consumer electronic devices such as stereos, TVs, VCRs, etc. – programmable pulse parameters – external analog LED circuitry • IRDA communication mode – not compatible with General Magic Cap Devices – allows communication with other IRDA devices such as FAX machines, copiers, printers, etc. – supported by the UART module within the PR31700 – external analog receiver preamp and LED circuitry – data rate = up to 115 kbps at 1 meter • IR FSK communication mode – compatible with GeneraI Magic Cap Devices – supported by the UART module within the PR31700 – external analog IR chip(s) perform frequency modulation to generate the desired IR communication mode protocol – data rate = up to 36000 bps at 3 meters • carrier detect state machine – periodically enables IR receiver to check if a valid carrier is present |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |