
3 of 12
RF5125
Rev A23 DS070515
7628 Thorndike Road, Greensboro, NC 27409-9421 · For sales or technical
support, contact RFMD at (+1) 336-678-5570 or sales-support@rfmd.com.
Pin
Function
Description
Interface Schematic
1NC
Not connected. May be connected to ground (GND).
2RF IN
RF input. See evaluation board schematic for details.
3RF IN
RF input. See evaluation board schematic for details.
See pin 2.
4NC
Not connected. May be connected to ground (GND).
5NC
Do not connect.
Note: VCC voltage may be applied to this pin without damage to, or affect-
ing the performance of, the RF5125.
6VREG1
Bias current control voltage for the first stage.
7VREG2
Bias current control voltage for the second stage. The VREG2 pin may be
connected to VREG1 through an external resistor bridge.
8PDETECT (or
N/C*)
Provides an output voltage proportional to the output RF level.
*In applications where the PDETECT function is not desired, this pin may
be left unconnected.
9NC
No-connect.
10
RF OUT
RF output.
11
RF OUT
Same as pin 10.
See pin 10.
12
RF OUT/
VC2
Power supply for second stage amplifier. Connect as shown on evaluation
board schematic.
13
NC
Not connected. May be connected to ground (GND).
14
VC1
Power supply for first stage amplifier. Connect as shown on evaluation
board schematic.
15
NC
Not connected. May be connected to ground (GND).
16
VCC
Supply voltage for the bias reference and control circuits. May be con-
nected with VC1 and VC2 (single-supply voltage).
Pkg
Base
GND
The center metal base of the QFN package provides DC and RF ground as
well as heat sink for the amplifier.
INPUT
MATCH
VCC
INTERSTAGE
MATCH
RF OUT
BIAS