| Electronic Components Datasheet Search |
|
PCA9665PW Datasheet(PDF) 6 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
PCA9665PW Datasheet(HTML) 6 Page - NXP Semiconductors |
|
6 / 91 page ![]() PCA9665_2 © NXP B.V. 2006. All rights reserved. Product data sheet Rev. 02 — 7 December 2006 6 of 91 NXP Semiconductors PCA9665 Fm+ parallel bus to I2C-bus controller 7. Functional description 7.1 General The PCA9665 acts as an interface device between standard high-speed parallel buses and the serial I2C-bus. On the I2C-bus, it can act either as a master or slave. Bidirectional data transfer between the I2C-bus and the parallel-bus microcontroller is carried out on a byte or buffered basis, using either an interrupt or polled handshake. 7.2 Internal oscillator The PCA9665 contains an internal 28.5 MHz oscillator which is used for all I2C-bus timing. The oscillator requires up to 550 µs to start-up after ENSIO bit is set to ‘1’. 7.3 Registers The PCA9665 contains eleven registers which are used to configure the operation of the device as well as to send and receive serial data. There are four registers that can be accessed directly and seven registers that are accessed indirectly by setting a register pointer. The four direct registers are selected by setting pins A0 and A1 to the appropriate logic levels before a read or write operation is executed on the parallel bus. The seven indirect registers require that the INDPTR (indirect register pointer, one of the four direct registers described above) is initially loaded with the address of the register in the indirect address space before a read or write is performed to the INDIRECT data field. For example, in order to write to the indirectly addressed I2CSCLL register, the INDPTR register should be loaded with 02h by performing a write to the direct INDPTR register (A1 = 0, A0 = 0). Then the I2CSCLL register can be programmed by writing to the INDIRECT data field (A1 = 1, A0 = 0) in the direct address space. Register mapping is described in Table 3, Table 4 and Figure 6. Remark: Do not write to any I2C-bus registers while the I2C-bus is busy and the PCA9665 is in master or addressed slave mode. [1] See Section 8.10 “Power-on reset” for more detail. Table 3. Direct register selection by setting A0 and A1 Register name Register function A1 A0 Read/Write Default I2CSTA status 0 0 R F8h INDPTR indirect register pointer 0 0 W 00h I2CDAT data 0 1 R/W 00h I2CCON control 1 1 R/W 00h[1] INDIRECT indirect data field access 1 0 R/W 00h |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |