AN1620 datasheet(22/50 Pages) ARISTA

22 / 50 page

The switch operates with two installed power supplies. At least one power supply must connect to a

power source. Two circuits provide redundancy protection. Rear Panel displays the location of the

power supplies on the rear panel of the switch.

Important:

Read all installation instructions before connecting the system to the power source.

Lire toutes les instructions d’installation avant de brancher le système à la source

d’alimentation.

•

Non-Redundant Configuration: Connect power to either of the two power supplies.

•

Redundant Power Supply Configuration: Connect power to both power supplies.

•

Power down the Switch: Remove all power cords and wires from the power supplies.

Important:

This equipment must be grounded. Never defeat the ground conductor.

Cet équipement doit être mis à la terre. Ne jamais modifier le conducteur de terre.

Important:

This unit requires overcurrent protection.

Cet appareil requiert une protection contre les surintensités.

4.2.1

AC Power Supplies

The following AC power supplies are supported.

•

PWR-1600AC

Figure 15: AC Power Supply displays an AC power supply, including the power socket on the right

side of the module. The AC power supply connects to a circuit that provides the required power, as

specified by Table 1: Switch Specifications (Dimensions and Weights).

Figure 15: AC Power Supply

1 Handle

3 Release

2 Status LED

The power supplies require power cables that comply with IEC-320. The accessory kit provides two

IEC-320 C13 to C14 power cables.

AN1620 Datasheet(PDF) 22 Page - Arista Networks, Inc